We are in a rest area and will need to get out of here, so going to look into getting towed or hauled out if here.
What needs to be done to properly do this?
Thanks
Seb
You may have to pull an axle. Not sure. I will let the experts here explain. The tow truck driver should know for sure. He may have to air you up from his truck too. So know where your air input fitting is.
Quote from: Gary Hatt - Publisher RVConversions.com on November 12, 2026, 06:07:12 PMYou may have to pull an axle. Not sure. I will let the experts here explain. The tow truck driver should know for sure. He may have to air you up from his truck too. So know where your air input fitting is.
Thanks Gary,
So, to air up, do we use the air fitting in the side engine door on the passenger side?
Seb
Look in the front tool bay near the ceiling inside should be a Scherader valve to hook to in there. driver side under floor.
Quote from: Dave5Cs on November 14, 2026, 09:02:35 AMLook in the front tool bay near the ceiling inside should be a Scherader valve to hook to in there. driver side under floor.
Ok, I found a shrader valve on a black steel tank that looks to be about 4 gallons. It has air hoses coming off of it and what looks like a pressure sensor on it.
Picture below.
Seb
(https://i.postimg.cc/636V7hDb/IMG-20261114-120027.jpg)
Thats the auxiliary air tank, not what you're looking for. Look up and to the right. Near the top of the door.
Quote from: thomasinnv on November 15, 2026, 06:17:45 AMThats the auxiliary air tank, not what you're looking for. Look up and to the right. Near the top of the door.
Ok, I see 4 shraders, labeled park brake, front brake, rear brake and one without a label. The one without a label seemed to have an air line that goes to tat auxiliary tank.
I'm guessing, to air up the bags I use the unlabeled one and then I would need to air up the park brake one to realease the park brake. Am I on the right track?
Seb
(https://i.postimg.cc/MZhVtmhh/IMG-20261115-100520.jpg)
Ok a flat bed is coming at 9 am to haul us to Oklahoma.
I have tried to air up the bus with an air compressor. It got to 90 lbs. and wouldn't go any higher.
It is a small compressor, 2.4 cfm, but it seems like it should have worked.
Ideas?
Thanks
Seb
Don't worry about it the tow driver will air it up ,the small compressor will not overcome a small high pressure leak, your bus has a 15cfm compressor that can over come the leaks so will the tow truck