Advertisement

HT-740 transmission drain plug simple question

Started by plyonsMC9, November 15, 2026, 06:57:29 PM

Previous topic - Next topic

plyonsMC9

Good evening bus folks.  On our 1983 MC9 I have a drain plug near the dip stick tube on the driver side of the HT-740 transmission pan (mated to the 6v-92 DD).  That plug has decided to get leaky.  It looks like a one inch plug, and I'm thinking it could be replaced with a standard galvanized 1" pipe plug and sealed up with pipe dope.  Am I on the right track here re bolt size? Size is not in my manuals.

Thank you bus folks! Phil
Northern Arizona / 1983 - MC9, 1995 MCI DL3-45

Advertisement

luvrbus

Use a black iron plug not galvanized, don't use tape use Permatex 59214 or Loctite 2087067 ,I use the Loctite  high temperature because of the  sump temperatures can reach 250+ degrees   ,FWIW the boss where the plug screws into sometimes the pan cracks in that area 
Life is short drink the good wine first

plyonsMC9

Thanks Clifford, I have this loctite purchased;

LOCTITE 242 Threadlocker for Automotive: High-Temp, Medium-Strength, Anaerobic | Blue

Hopefully not a cracked pan, but will investigate w/the plug out. Will make sure I have the black iron pipe plug.

Kind regards, Phil
Northern Arizona / 1983 - MC9, 1995 MCI DL3-45